Installation Guide

Thank you for choosing Viziotechnik.

Your tap has been designed and engineered to deliver outstanding performance, reliability and ease of use.

To ensure optimal installation and long-term functionality, we recommend carefully reading the installation and user manual before proceeding. The guide contains essential information for correct installation, safe operation and proper care of your tap.

The installation manual applies to all VIZIO tap models.

Download the installation manual

The first thing to do after removing the tap from the packaging is to tighten the mounting stem to the tap. To do this, hold the tap with one hand and tighten the stem with the other hand until it stops turning. This ensures that the stem is fully secured to the tap.

Check that the flexible hoses are tightly secured, but do not overtighten them — just make sure they are properly screwed in.

Place the tap in the sink hole and position yourself under the sink to proceed with the installation of the mounting system.

Insert the black gasket and then the steel disc so that they rest underneath the kitchen sink. Insert the mounting collar and hand-tighten it all the way.

Once it is sufficiently tight, secure everything by tightening the two screws on the collar with a Phillips screwdriver.

Regular maintenance

Clean the aerator with a 50/50 mixture of vinegar and water

1. Unscrew the aerator following the instructions for your specific kitchen mixer.
2. Fill a cup with half water and half vinegar and fully immerse the aerator. Be careful NOT to immerse the chrome parts as you may damage the faucet's finish.
3. Let it soak overnight to dissolve all stains and dirt. Leave the aerator submerged in this mixture for at least 6-12 hours, depending on the level of limescale in your area.
4. Once the limescale is removed, rinse thoroughly with clean running water and then screw it back in.

Clean the dual-spray showerhead

1. To clean the dual-spray showerhead of your kitchen faucet, follow these instructions.
2. To remove stains or dirt, first rinse with clean water and then use a 50/50 mixture of vinegar and water. Only immerse the plastic parts in this solution. PLEASE, DO NOT IMMERSE METAL PARTS IN THE VINEGAR SOLUTION AS IT MAY DISCOLOR THE SURFACE.
3. After finishing, rinse with clean water and reassemble the aerator as described in the instructions.

Troubleshooting

If you have already installed your faucet and are experiencing problems, visit the page Troubleshooting.